3,009 bytes added
, 09:07, 22 May 2007
== smeserver-atftp-server ==
Maintainer: [mailto:smeserver@batley.id.au Trevor Batley]<br>
Current vesrion: 1.0-1
=== Description ===
This contribution adds a tftp server (atftp-server) to your smeserver (primarily used by workstations that are using the pxeboot protocol to retrieve boot images and parameters from the server).
It was produced to support my [[Thinclient|smeserver-thinclient]] contrib, but can be used independently.
I also have a sister contrib that uses [[Tftp_server|tftp-server]], if you prefer that server. It works the same as this one and is interchangeable.
=== Requires ===
*smeserver >= 7.0
*atftp-server >= 0.7-3
=== Installation ===
This contrib is currently held in the smedev repository (I will try to move it into smeextras or smeaddons), so the following commands will install on your smeserver. atftp-server is currently available in the [[dag|dag]] repository.
yum --enablerepo=smedev --enablerepo-dag install smeserver-atftp-server
Officially you should then need to activate the database changes etc., but this is not required for this package.
signal-event post-upgrade
signal-event reboot
The tftpd status is controlled via the Thin Clients server-manager panel if you have installed my [[Thinclient|smeserver-thinclient]] contrib.
If you haven't, you'll need to enable the atftp server and expand all the templates etc.
config setprop tftpd status enabled
signal-event tftpd-conf
If for any reason the atftp server isn't running, try:
/etc/init.d/supervise/tftpd restart
=== Defaults ===
You shouldn't need to play with any parameters (except status). The defaults and allowed values are listed below.
{| border="1" cellpadding="5"
! <prop>
! default <value>
! allowed Values
! description
|-
| status
| disabled
| enabled/disabled
|
|-
| access
| private
| private/public/localhost
| private = internal interface ONLY
public = all interfaces
localhost = localhost ONLY
disabled = none
|-
| user
| root
| root/nobody
| should default to nobody, but this doesn't work
|-
| timeout
| default
| default/300
| default = 900 seconds (15 minutes)
|-
| UDPPort
| 69
| any port
|
|-
| directory
| /tftpboot
| any directory
|
|-
|}
These settings can be set/changed via
config setprop tftpd <prop> <value>
signal-event tftpd-conf
=== Uninstall ===
yum remove smeserver-atftp-server atftp-server
Everything should be turned off, but if not, or you just want to make sure
/etc/init.d/supervise/tftpd stop
An error saying that /etc/init.d/supervise/tftpd does not exist should be returned
=== Source ===
The source for this contrib can be found in the smeserver [http://smeserver.cvs.sourceforge.net/smeserver/smeserver-atftp-server/ CVS] on sourceforge.
=== Bugs ===
Please raise bugs under the SME-Contribs section in {{BugzillaFileBug|product=|component=|title=bugzilla}}and select the smeserver-atftp-server component or use {{BugzillaFileBug|product=SME%20Contribs|component=smeserver-atftp-server|title=this link}}.
----
[[Category: Contrib]]