Changes

# Shut down & install old drive and start machine.

# Shut down & install old drive and start machine.

# mkdir /mnt/tmp

# mkdir /mnt/tmp

# mount /dev/hdb2 /mnt/tmp (adjust "hdb2" according to where the old drive is installed).

# mount /dev/hdxn /mnt/tmp (adjust "hdxn" according to which channel the drive is connected to and which partition the data on the old drive is located ie use fdisk -l /dev/hdx to determine this, usually it will be the largest partition, in most cases this will be /dev/hda2 but in some cases may be /dev/hda3).

# db configuration setprop backup Program CopyFromDisk status enabled

# db configuration setprop backup Program CopyFromDisk status enabled

# signal-event pre-restore

# signal-event pre-restore