3,254
edits
Changes
Jump to navigation
Jump to search
Line 15:
Line 15: − + + + + + + + + + + + + + + + + + + + + + + − + + Line 30:
Line 52: − * '''for sme8''' − yum --enablerepo=stephdl install smeserver-check4updates − − * '''for sme9''' Line 46:
Line 64: + + + +
→Installation
=== Installation ===
=== Installation ===
====SME10====
<tabs container><tab name="For SME 10">
Install in the usual way:
Install in the usual way:
yum install smeserver-check4updates --enablerepo=smecontribs
yum install smeserver-check4updates --enablerepo=smecontribs
</tab><tab name="For SME 9">
This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured).
You can check the repo status as follows
db yum_repositories show stephdl
If you receive no output then the repo is not configured on your SME server.
Then run the following commands to install the Check4updates contrib on your SME Server.<br />
yum --enablerepo=smecontribs install smeserver-check4updates
You have to set the repositories you want to check, you must enabled them before as it is asked [http://wiki.contribs.org/Category:Yum_Repository on this page]<br />
'''Repositories have to be separated by a coma ',''''<br />
for example
config setprop check4updates repositories fws,stephdl
Then activate the database changes as follows:
signal-event post-upgrade; signal-event reboot
or if you do not want to restart the server, simply do
signal-event console-save
====Earlier====
</tab>
<tab name="For SME 8">
This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured).
This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured).
Then run the following commands to install the Check4updates contrib on your SME Server.<br />
Then run the following commands to install the Check4updates contrib on your SME Server.<br />
yum --enablerepo=smecontribs install smeserver-check4updates
yum --enablerepo=smecontribs install smeserver-check4updates
You have to set the repositories you want to check, you must enabled them before as it is asked [http://wiki.contribs.org/Category:Yum_Repository on this page]<br />
You have to set the repositories you want to check, you must enabled them before as it is asked [http://wiki.contribs.org/Category:Yum_Repository on this page]<br />
or if you do not want to restart the server, simply do
or if you do not want to restart the server, simply do
signal-event console-save
signal-event console-save
yum --enablerepo=stephdl install smeserver-check4updates
</tab>
</tabs>
===Usage===
===Usage===