Line 15: |
Line 15: |
| === Installation === | | === Installation === |
| | | |
− | ====SME10==== | + | <tabs container><tab name="For SME 10"> |
| | | |
| Install in the usual way: | | Install in the usual way: |
| | | |
| yum install smeserver-check4updates --enablerepo=smecontribs | | yum install smeserver-check4updates --enablerepo=smecontribs |
| + | </tab><tab name="For SME 9"> |
| + | This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured). |
| + | |
| + | You can check the repo status as follows |
| + | db yum_repositories show stephdl |
| + | If you receive no output then the repo is not configured on your SME server. |
| + | |
| + | Then run the following commands to install the Check4updates contrib on your SME Server.<br /> |
| + | |
| + | yum --enablerepo=smecontribs install smeserver-check4updates |
| + | You have to set the repositories you want to check, you must enabled them before as it is asked [http://wiki.contribs.org/Category:Yum_Repository on this page]<br /> |
| + | |
| + | '''Repositories have to be separated by a coma ',''''<br /> |
| + | |
| + | for example |
| + | config setprop check4updates repositories fws,stephdl |
| + | |
| + | Then activate the database changes as follows: |
| + | signal-event post-upgrade; signal-event reboot |
| + | or if you do not want to restart the server, simply do |
| + | signal-event console-save |
| | | |
− | ====Earlier==== | + | </tab> |
| + | <tab name="For SME 8"> |
| This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured). | | This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured). |
| | | |
Line 30: |
Line 52: |
| Then run the following commands to install the Check4updates contrib on your SME Server.<br /> | | Then run the following commands to install the Check4updates contrib on your SME Server.<br /> |
| | | |
− | * '''for sme8'''
| |
− | yum --enablerepo=stephdl install smeserver-check4updates
| |
− |
| |
− | * '''for sme9'''
| |
| yum --enablerepo=smecontribs install smeserver-check4updates | | yum --enablerepo=smecontribs install smeserver-check4updates |
| You have to set the repositories you want to check, you must enabled them before as it is asked [http://wiki.contribs.org/Category:Yum_Repository on this page]<br /> | | You have to set the repositories you want to check, you must enabled them before as it is asked [http://wiki.contribs.org/Category:Yum_Repository on this page]<br /> |
Line 46: |
Line 64: |
| or if you do not want to restart the server, simply do | | or if you do not want to restart the server, simply do |
| signal-event console-save | | signal-event console-save |
| + | yum --enablerepo=stephdl install smeserver-check4updates |
| + | |
| + | </tab> |
| + | </tabs> |
| | | |
| ===Usage=== | | ===Usage=== |