Diskusage
Diskusage for SME Server
Maintainer
Darrel May (dmay) at myEZserver (Software)
Description
- Diskusage adds a panel to the server-manager showing filesystem, i-bay and user statistics.
Step-by-step silly HowTo for installation.
It reflects the experiences I've had during install and are probably not always applicable.
This howto are intended for Linux-newbies.
Check latest releases at http://mirror.contribs.org/smeserver/contribs/dmay/smeserver/7.x/
Replace filenames if you use other versions.
Installation
1. Log in (with username root) to the SMEserver console.
2. Download smeserver-diskusage
wget http://mirror.contribs.org/smeserver/contribs/dmay/smeserver/7.x/smeserver-diskusage-0.0.1-1dmay.noarch.rpm
3. Install smeserver-diskusage
yum localinstall smeserver-diskusage-0.0.1-1dmay.noarch.rpm
You will get a y/N-question, answer y if it looks fine.
4. Instructions at the end of previous installation advices the following commands:
signal-event post-upgrade and signal-event reboot
but you can skip that (not necessary) and move on.
5. Open your webbrowser and go to the server-manager.
Under "Administration" there should be a new line named "Disk usage".
Additional information
If you connect to the SMEserver console by Putty ssh-client (or similar) you can copy and paste the commands (very convenient).
Please note that this was written in april 2007, if the software change then this howto may be outdated.
Please do edit if you find errors or have improvements, but make sure that it works!
Good luck /Per
Tested software versions
Host: SMEserver 7.1.3
Software: smeserver-diskusage-0.0.1-1dmay.noarch.rpm