Difference between revisions of "Tftp server"
(→Source) |
m (→Bugs: typo) |
||
| Line 80: | Line 80: | ||
Please raise bugs under the SME-Contribs section in {{BugzillaFileBug|product=|component=|title=bugzilla}}and select the smeserver-tftp-server component or use {{BugzillaFileBug|product=SME%20Contribs|component=smeserver-tftp-server|title=this link}}. | Please raise bugs under the SME-Contribs section in {{BugzillaFileBug|product=|component=|title=bugzilla}}and select the smeserver-tftp-server component or use {{BugzillaFileBug|product=SME%20Contribs|component=smeserver-tftp-server|title=this link}}. | ||
---- | ---- | ||
| − | [[Category: Contrib]] | + | [[Category:Contrib]] |
| − | [[Category: Asterisk]] | + | [[Category:Asterisk]] |
| − | [[Category: Administration]] | + | [[Category:Administration]] |
Revision as of 20:07, 10 October 2014
smeserver-tftp-server
Maintainer: Trevor Batley
Current vesrion: 1.0-2
Description
This contribution adds a tftp server (tftp-server) to your smeserver (primarily used by workstations that are using the pxeboot protocol to retrieve boot images and parameters from the server).
It was produced to support my smeserver-thinclient contrib, but can be used independently.
Requires
- smeserver >= 7.0
- tftp-server >= 0.39
Installation
This contrib is held in the smecontribs repository, so the following commands will install on your smeserver.
yum --enablerepo=smecontribs install smeserver-tftp-server
Note: this will download and install the latest tftp-server from the Centos base repository, so if you don't have that repository ebnabled, please use the following command
yum --enablerepo=smecontribs --enablerepo=base install smeserver-tftp-server
Officially you should then need to apply the database changes etc., but this is not required for this package.
signal-event post-upgrade signal-event reboot
The tftpd status is controlled via the Thin Clients server-manager panel if you have installed my smeserver-thinclient contrib.
If you haven't, you'll need to enable the tftp server and expand all the templates etc.
config setprop tftpd status enabled signal-event tftpd-conf
If for any reason the tftp server isn't running, try:
/etc/init.d/supervise/tftpd restart
Defaults
You shouldn't need to play with any parameters (except status). The defaults and allowed values are listed below.
| <prop> | default <value> | allowed Values | description |
|---|---|---|---|
| status | disabled | enabled/disabled | |
| user | root | root/nobody | should default to nobody, but this doesn't work |
| directory | /tftpboot | any directory |
These settings can be set/changed via
config setprop tftpd <prop> <value> signal-event tftpd-conf
Uninstall
yum remove smeserver-tftp-server tftp-server
Everything should be turned off, but if not, or you just want to make sure
/etc/init.d/tftpd stop
An error saying that /etc/init.d/supervise/tftpd does not exist should be returned
Source
The source for this contrib can be found in the smecontribs CVS on sourceforge.
Bugs
Please raise bugs under the SME-Contribs section in bugzilla and select the smeserver-tftp-server component or use this link .
