Changes

From SME Server
Jump to navigationJump to search

Smbstatus (view source)

Revision as of 16:17, 17 March 2014

279 bytes added ,  16:17, 17 March 2014
repo setup notes amended
Line 10: Line 10:     
=== Installation ===
 
=== Installation ===
−
This contrib is currently held in the [[stephdl]] repository, so the following commands will install on your SME Server.
+
This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured).  
    +
You can check the repo status as follows
 +
db yum_repositories show stephdl
 +
If you receive no output then the repo is not configured on your SME server.
 +
 +
Then run the following commands to install the Smbstatus contrib on your SME Server.
 
  yum --enablerepo=stephdl install smeserver-smbstatus
 
  yum --enablerepo=stephdl install smeserver-smbstatus
−
 
+
Then activate the database changes as follows:
−
You will then need to activate the database changes etc.
  −
The 'official' way is to perform
  −
 
   
  signal-event post-upgrade;  signal-event reboot
 
  signal-event post-upgrade;  signal-event reboot
  
RayMitchell
624

edits

Retrieved from "https://wiki.koozali.org/Special:MobileDiff/23877"

Navigation menu