Line 10: |
Line 10: |
| | | |
| === Installation === | | === Installation === |
− | This contrib is currently held in the [[stephdl]] repository, so the following commands will install on your SME Server. | + | This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured). |
| | | |
| + | You can check the repo status as follows |
| + | db yum_repositories show stephdl |
| + | If you receive no output then the repo is not configured on your SME server. |
| + | |
| + | Then run the following commands to install the Raidstatus contrib on your SME Server. |
| yum --enablerepo=stephdl install smeserver-raidstatus | | yum --enablerepo=stephdl install smeserver-raidstatus |
− | | + | Then activate the database changes as follows: |
− | You will then need to activate the database changes etc.
| |
− | The 'official' way is to perform
| |
− | | |
| signal-event post-upgrade; signal-event reboot | | signal-event post-upgrade; signal-event reboot |
− | or if you do not want to restart the server | + | or if you do not want to restart the server, simply do |
| signal-event console-save | | signal-event console-save |
| Go to the Server Manager and check the status of raid | | Go to the Server Manager and check the status of raid |
| | | |
− | In case of your raid is desynchronized, please check our documentation http://wiki.contribs.org/Raid:Manual_Rebuild. | + | In case the raid is unsynchronized, please check the documentation at http://wiki.contribs.org/Raid:Manual_Rebuild. |
| | | |
| === Usage === | | === Usage === |