777
edits
Changes
From SME Server
Jump to navigationJump to searchUpdateFrom7.5to8.0b6 (view source)
Revision as of 15:17, 10 September 2010
, 15:17, 10 September 2010no edit summary
#When it has done, then do a ''Signal-event post-upgrade'' and ''signal-event reboot'' and check that the data is correct and that your server does the job you expect of it.
#When it has done, then do a ''Signal-event post-upgrade'' and ''signal-event reboot'' and check that the data is correct and that your server does the job you expect of it.
#Once you are happy with the new software, then you can add the other hard drive as follows:
#Once you are happy with the new software, then you can add the other hard drive as follows:
##blah blah
##Close down the server and disconnect the hard drive and reconnect the "spare" drive and boot from it.
##Get into a terminal session
##Overwrite the initial blocks on the drive by ''dd if=/dev/zero of=/dev/sdc count=255''. This stops SME8 thinking that the spare drive has a raid partion on it and thus not booting properly. Note that the ''/dev/sdc'' must be replaced by the device name of your spare hard drive.
##Close down the system
##Connect in the primary drive
##Reboot, and then use the Console menu option to start the synchronisation of the new drive
#If you decide that you need to reverse back to the 7.5 system, then you can do it as follows:
#If you decide that you need to reverse back to the 7.5 system, then you can do it as follows:
##blah blah
##blah blah
smeserver-userpanel
smeserver-userpanel
smeserver-mailsorting
smeserver-mailsorting
logwatch
rkhunter
