689
edits
Changes
From SME Server
Jump to navigationJump to searchUninterruptable Power Supply (view source)
Revision as of 21:50, 17 January 2010
, 21:50, 17 January 2010Clarified default configuration under SME
==Default Configuration (USB)==
==Default Configuration (USB)==
Most USB connected UPS's will work with the default settings. If using a USB connection just enable nut as follows:
The default configuration in SME Server as set by the database properties for 'nut' is
Model = usbhid-ups
status = disabled
type = service
{Note box|Absence of a 'Master' property setting defaults the configuration to being a Master setup. That is a UPS connected directly to the server via USB or serial cable is assumed. See later for setting as a Slave.
The default is for nut to be disabled, that is no UPS connected}
Most USB connected UPS's will work with these default settings. If using a USB connection just enable nut as follows:
config setprop nut status enabled
config setprop nut status enabled
signal-event reboot
signal-event reboot
If your USB UPS does not work properly OR you have a '''serial device''' then follow the Configuration Options below.
If your USB UPS does not work properly OR you have a '''serial device''' then follow the Configuration Options below as required.
==Configuration Options==
==Configuration Options==
