Line 35: |
Line 35: |
| {{Tip box| Do not press the 'Join Domain' button until you have completed the changes below on all three of the dialogue tabs}} | | {{Tip box| Do not press the 'Join Domain' button until you have completed the changes below on all three of the dialogue tabs}} |
| *On the 'User Information' tab tick 'Enable Winbind Support' and press the 'Configure Winbind ' button. | | *On the 'User Information' tab tick 'Enable Winbind Support' and press the 'Configure Winbind ' button. |
− | A 'Winbind Configuration' dialogue opens. Complete the boxes with the relevant information and press OK | + | *:A 'Winbind Configuration' dialogue opens. Complete the boxes with the relevant information and press OK |
| Winbind Domain - this is the Windows Workgroup name for your SME Server | | Winbind Domain - this is the Windows Workgroup name for your SME Server |
| Security - set this to domain | | Security - set this to domain |
Line 42: |
Line 42: |
| Allow Offline Login - tick | | Allow Offline Login - tick |
| *Change to the 'Authentication' tab. Check 'Enable Winbind Support' is ticked and press the 'Configure Winbind' button. | | *Change to the 'Authentication' tab. Check 'Enable Winbind Support' is ticked and press the 'Configure Winbind' button. |
− | A 'Winbind Settings' dialogue opens. Check the values are the same as above and press OK. | + | *:A 'Winbind Settings' dialogue opens. Check the values are the same as above and press OK. |
| *Change to the Options tab and check the following are ticked or set | | *Change to the Options tab and check the following are ticked or set |
| Use Shadow Passwords | | Use Shadow Passwords |
Line 70: |
Line 70: |
| pam password change = yes | | pam password change = yes |
| hostname lookup = yes | | hostname lookup = yes |
− | {{Replace <WORKGROUP> above (and below) with the 'Windows workgroup' name of your SME server. Replace <ip of sme server> above with the internal network ip address of your SME server.
| + | *:Replace <WORKGROUP> above (and below) with the 'Windows workgroup' name of your SME server. Replace <ip of sme server> above with the internal network ip address of your SME server. |
− | Note box| If you run the 'System - Administration - Authentication' tool again your amendments will be lost}} | + | {{Note box| If you run the 'System - Administration - Authentication' tool again your amendments will be lost}} |
| *To check validation of smb.conf, run | | *To check validation of smb.conf, run |
| testparm | | testparm |
Line 78: |
Line 78: |
| wbinfo -g | | wbinfo -g |
| smbtree | | smbtree |
− | If it doesn't appear to have worked then run | + | *:If it doesn't appear to have worked then run |
| net rpc join -D <WORKGROUP> -U admin | | net rpc join -D <WORKGROUP> -U admin |
− | Enter the admin password for the SME server when prompted and you should get a message, | + | *:Enter the admin password for the SME server when prompted and you should get a message, |
| Joined domain <WORKGROUP> | | Joined domain <WORKGROUP> |
| | | |