board, director
297
edits
Changes
From SME Server
Jump to navigationJump to searchSoftware Collections:Python (view source)
Revision as of 07:30, 14 October 2017
, 07:30, 14 October 2017→Install application
===Installation===
===Installation===
To be able to install an application from the Software Collections, one '''must''' install software collections first. Please see [[Software collections]] on how to install this.
To be able to install an application from the Software Collections, one '''must''' install software collections first. Please see [[Software collections]] on how to install this.
The below procedure if for Python 3.3, but you can also install Python 2.7 instead or even along side. Simply replace all '33' metionings with '27'. To switch between the two versions, you need to remove the enablepythonxx.sh script from the /etc/profile.d directory as described below.
====Install application====
====Install application====
After installing the scl-python33 repository, Python can be installed by issuing the following command:
After installing the scl-python33 repository, Python can be installed by issuing the following command:
yum install python33 --enablrepo=scl-python33
yum install python33 --enablerepo=centos-sclo-rh
Once installed, the application is installed on your SME Server at '''/opt/rh/python33-''' as an isolated environment for the application.
Once installed, the application is installed on your SME Server at '''/opt/rh/python33''' as an isolated environment for the application.
====Test installed application====
====Test installed application====
====Start application at boot time====
====Enable the python 3.3 environment at boot time====
The preferred way to enable scl python33 permanently at logout or (re)boot is to add a custom script called 'enablepython33.sh to /etc/profiles.d/ directory with the following content:
The preferred way to enable scl python33 permanently at logout or (re)boot is to add a custom script called 'enablepython33.sh' to /etc/profile.d/ directory with the following content and make it executable.
#!/bin/sh
#!/bin/sh
