653
edits
Changes
Jump to navigation
Jump to search
Line 91:
Line 91: − [[bugzilla: 6702]] − {{Note box|With some later generation motherboards you may need to set SATA AHCI mode to AHCI instead of IDE in the Bios to enable the installation to commence and complete.}} − − When booting from the installation CD you will get a boot prompt where you can simply '''press Enter to start''' the standard installation (or upgrade) routine. Line 102:
Line 98: − [[bugzilla: 6401]]+ − − − [[Bugzilla: 6996]] − {{Note box|Hardware that may include an internal tape drive may experience a Installer fail immediately after cd check or skipping cd check, see disconnect the tape drive retry install again }} − − {{Note box|SME9 only - If you are configuring your system with RAID1 support, notice that your step 4 below will be slightly different. If you skipped section 5.2 RAID1 Support (Disk Mirroring), it would be advisable to read it before proceeding.}}
SME Server:Documentation:Administration Manual:Chapter5 (view source)
Revision as of 00:49, 8 April 2021
, 00:49, 8 April 2021→Installing the Software
====Installing the Software====
====Installing the Software====
{{Tip box|You have some command Line Options that you can use to set some parameters such as LVM (activated by default), '''SME9 only''' - software Raid option (none,0,1,5,6). You can use the function keys F1 to F5 to get more information about different boot options. see [[Booting]]}}
{{Tip box|You have some command Line Options that you can use to set some parameters such as LVM (activated by default), '''SME9 only''' - software Raid option (none,0,1,5,6). You can use the function keys F1 to F5 to get more information about different boot options. see [[Booting]]}}
Afterwards you can choose which language you want to use for the following installation process.
Afterwards you can choose which language you want to use for the following installation process.
{{Note box|If you are configuring your system with RAID1 support, notice that your step 4 below will be slightly different. If you skipped section 5.2 RAID1 Support (Disk Mirroring), it would be advisable to read it before proceeding.}}
{{Note box|If your cdrom is set as hda then the following error message may appear in the console during startup: "Setting up Logical Volume Management: /dev/hda: open failed: No medium found 2 logical volumes(s) in volume group "main" now active"}}
'''Step 1''': Insert the USB or CD-ROM media.
'''Step 1''': Insert the USB or CD-ROM media.