Line 18: |
Line 18: |
| * 3 Drives - Software RAID 1 | | * 3 Drives - Software RAID 1 |
| | | |
| + | If you use a true hardware raid controller to manage your hard drives and choose noraid during install, your system will still be configured with RAID1. |
| | | |
| ====Hard Drive Layout==== | | ====Hard Drive Layout==== |
Line 156: |
Line 157: |
| | | |
| # Shut down and install one larger drive in system for one old HD. Unplug any USB-connected drives. | | # Shut down and install one larger drive in system for one old HD. Unplug any USB-connected drives. |
− | # Boot up and manage raid to add new (larger) drive to system. | + | # Boot up and login to the admin console and use option 5 to add the new (larger) drive to system. |
| # Wait for raid to fully sync. | | # Wait for raid to fully sync. |
| # Repeat steps 1-3 until all drives in system are upgraded to larger capacity. | | # Repeat steps 1-3 until all drives in system are upgraded to larger capacity. |
| # Ensure all drives have been replace with larger drives and array is in sync and redundant! | | # Ensure all drives have been replace with larger drives and array is in sync and redundant! |
| # Issue the following commands: | | # Issue the following commands: |
| + | |
| + | {{Note box|SME9 uses /dev/md1 not /dev/md2.}} |
| | | |
| mdadm --grow /dev/md2 --size=max | | mdadm --grow /dev/md2 --size=max |
Line 205: |
Line 208: |
| # Reboot and ensure all drives have been replaced with larger drives and array is in sync and redundant! | | # Reboot and ensure all drives have been replaced with larger drives and array is in sync and redundant! |
| # Issue the following commands: | | # Issue the following commands: |
| + | |
| + | {{Note box|SME9 uses /dev/md1 not /dev/md2.}} |
| | | |
| mdadm --grow /dev/md2 --size=max | | mdadm --grow /dev/md2 --size=max |
Line 490: |
Line 495: |
| sfdisk /dev/sdc < tmp.out | | sfdisk /dev/sdc < tmp.out |
| | | |
− | </li><li>Repeat the last step for each new hd (sdd, sde ecc.). | + | </li><li>Repeat the last step for each new hd (sdd, sde etc.). |
| </li><li>Create the new array | | </li><li>Create the new array |
| mdadm --create /dev/md2 -c 256 --level=5 --raid-devices=2 /dev/sda2 /dev/sdb2 | | mdadm --create /dev/md2 -c 256 --level=5 --raid-devices=2 /dev/sda2 /dev/sdb2 |
Line 514: |
Line 519: |
| mdadm --add /dev/md2 /dev/sdc2 | | mdadm --add /dev/md2 /dev/sdc2 |
| | | |
− | </li><li>Repeat the last step for each new hd (sdd2, sde2 ecc.) | + | </li><li>Repeat the last step for each new hd (sdd2, sde2 etc.) |
| | | |
| </li><li>Grow the array | | </li><li>Grow the array |