3,263
edits
Changes
Jump to navigation
Jump to search
Line 954:
Line 954: − + + + + + + + + + + + + + + + + + + +
→Allow SMTP relay of mail without encryption/authentication
Change the configuration of the system from the default, so that it no longer requires encryption/authentication before allowing relaying of mail.
Change the configuration of the system from the default, so that it no longer requires encryption/authentication before allowing relaying of mail.
Disable smtp authentication as shown in [[Bugzilla: 6522]]
* For most case, you really want to allow few specific clients on your LAN or trusted networks, this is done by setting a coma separated list of ip this way (replace IP1, IP2, IP3 by valid ips).
config set qpsmtpd UnauthenticatedRelayClients IP1,IP2,IP3
signal-event email-update
* In some case you would have a whole dedicated network with appliances needing to send email without auth, this is done this way
db networks setprop {$network} RelayRequiresAuth disabled
signal-event email-update
* In case you needs are not fulfilled because you need to accommodate a list of remote IP or a sub network of a larger trusted network, you can create a custom template. Here for reference the accepted formats:
mkdir -p /etc/e-smith/templates-custom/var/service/qpsmtpd/config/relayclients
# a subnetwork by only using a prefix of full ip
echo "10.10.0.">> /etc/e-smith/templates-custom/var/service/qpsmtpd/config/relayclients/80custom
# an external ip
echo "99.10.1.23" >> /etc/e-smith/templates-custom/var/service/qpsmtpd/config/relayclients/80custom
# an external network you control
echo "164.163.12.1/30" >> /etc/e-smith/templates-custom/var/service/qpsmtpd/config/relayclients/80custom
signal-event email-update
* Disable smtp authentication on all local interfaces as shown in [[Bugzilla: 6522]]
config setprop qpsmtpd RelayRequiresAuth disabled
config setprop qpsmtpd RelayRequiresAuth disabled