3,254
edits
Changes
Jump to navigation
Jump to search
Line 12:
Line 12: − + − This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured). + − You can check the repo status as follows+ − db yum_repositories show stephdl − If you receive no output then the repo is not configured on your SME server. + + + − + + + + + + + + − ====SME9==== − + + +
→Installation
=== Installation ===
=== Installation ===
====SME8====
<tabs container>
<tab name="For sme10">
yum --enablerepo=smecontribs install ssmeserver-smbstatus
Go to the Server Manager and see how many hosts are connected.
</tab>
<tab name="For sme9">
Then run the following commands to install the Smbstatus contrib on your SME Server.
Then run the following commands to install the Smbstatus contrib on your SME Server.
yum --enablerepo=stephdl install smeserver-smbstatus
yum --enablerepo=smecontribs install smeserver-smbstatus
Then activate the database changes as follows:
Then activate the database changes as follows:
signal-event post-upgrade; signal-event reboot
signal-event post-upgrade; signal-event reboot
Go to the Server Manager and see how many hosts are connected.
Go to the Server Manager and see how many hosts are connected.
</tab>
<tab name="For sme8">
This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here [[stephdl]] (if not already configured).
You can check the repo status as follows
db yum_repositories show stephdl
If you receive no output then the repo is not configured on your SME server.
Then run the following commands to install the Smbstatus contrib on your SME Server.
Then run the following commands to install the Smbstatus contrib on your SME Server.
yum --enablerepo=smecontribs install smeserver-smbstatus
yum --enablerepo=stephdl install smeserver-smbstatus
Then activate the database changes as follows:
Then activate the database changes as follows:
signal-event post-upgrade; signal-event reboot
signal-event post-upgrade; signal-event reboot
Go to the Server Manager and see how many hosts are connected.
Go to the Server Manager and see how many hosts are connected.
</tab>
</tabs>
=== Uninstall ===
=== Uninstall ===