877
edits
Changes
Jump to navigation
Jump to search
Line 253:
Line 253: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
FreePBX and Asterisk on Koozali SME Server
db yum_repositories setprop asterisk-current Exclude php-*
db yum_repositories setprop asterisk-current Exclude php-*
signal-event yum-modify
signal-event yum-modify
===Migration from earlier versions===
There is currently no upgrade path between versions. Backup/Restore will most likely not work.
Apparently this is planned for v14+
In the meantime some notes on manually upgrading. This was based on moving from asterisk 1.8.x and an old version of FreepBX.
First, make sure you backup ABSOLUTELY everything. In different ways and in different places.
A straight copy of /etc/asterisk and /opt/freepbx plus a complete database dump at least.
It will be better if you have a completely clean install, preferably on a VM where you can snapshot the basic install and go back if you need to.
I took a copy of the freepbx DB and imported it completely into a different server. I could then do a side by side comparison of tables and data.
Here are some basic tables that you will need, though they may not all be required depending on your configuration
General
modules (for reference as to what you already have installed)
sip (most entries required, but manual checking required)
sipsettings (for reference - do not INSERT)
freepbxsettings (for reference - do not INSERT)
Trunks and Routes
trunks
trunk_dialpatterns
incoming
outbound_routes
outbound_route_patterns
outbound_routes_sequence
outbound_route_trunk
Other
ringgroups
queueprio
queues_config
queues_details
Device and User mode
devices
users
Extension mode
extensions
freepbx_users - does not exist in v13
I exported each table and a table from the new install to compare, particularly items like field lengths, and KEYS. Some old tables did not have Primary keys set.
I then copied the 'INSERT INTO' section into phpmyadmin/sql section on the new server.
If you swap from Extension to Device and User mode I found that once I had inserted the data I had to go into FreePBX, open each record, and Submit, finally followed by Apply Config. This seemed to update the DB.
= Security =
= Security =