5,576
edits
Changes
Jump to navigation
Jump to search
Line 22:
Line 22: − − − You will need to manually enable the old sme7 smetest repo until sme8.x repos are fully populated so your sme8 server can access the compatible package, as follows) − − db yum_repositories set sme7test repository \ − GPGCheck yes \ − MirrorList http://distro.ibiblio.org/pub/linux/distributions/smeserver/mirrorlist/smetest-7 \ − Name 'SME 7 - test' \ − Visible no \ − status disabled − − signal-event yum-modify − Wait a minute or two for yum to finish, you can check if yum is still active using − top -i − (Ctrl c to exit) − then do − yum clean all − − To get the dependency & the sme 8.x compatible package both installed install use this command − yum install smeserver-webshare --enablerepo=sme7test --enablerepo=smecontribs − signal-event post-upgrade; signal-event reboot −
→Installation
yum install --enablerepo=smecontribs smeserver-webshare
yum install --enablerepo=smecontribs smeserver-webshare
3. Instructions at the end of previous installation advises the following commands:
3. Instructions at the end of previous installation advises the following commands: