624
edits
Changes
Jump to navigation
Jump to search
Line 25:
Line 25: − (manually enable this repo so your sme8 server can access it)+ + + + + + + + + + + + + + + + + + + + +
Additional installation notes for sme8.x
Note: For sme8 there is a newer compatible rpm, smeserver-webshare-1.0.0-10.el4.sme.noarch.rpm
Note: For sme8 there is a newer compatible rpm, smeserver-webshare-1.0.0-10.el4.sme.noarch.rpm
yum install --enablerepo=smetest smeserver-webshare
yum install --enablerepo=smetest smeserver-webshare
You will need to manually enable the old sme7 smetest repo until sme8.x repos are fully populated so your sme8 server can access the compatible package, as follows)
db yum_repositories set sme7test repository \
GPGCheck yes \
MirrorList http://distro.ibiblio.org/pub/linux/distributions/smeserver/mirrorlist/smetest-7 \
Name 'SME 7 - test' \
Visible no \
status disabled
signal-event yum-modify
Wait a minute or two for yum to finish, you can check if yum is still active using
top -i
(Ctrl c to exit)
then do
yum clean all
To get the dependency & the sme 8.x compatible package both installed install use this command
yum install smeserver-webshare --enablerepo=sme7test --enablerepo=smecontribs
signal-event post-upgrade; signal-event reboot
3. Instructions at the end of previous installation advises the following commands:
3. Instructions at the end of previous installation advises the following commands: