665
edits
Changes
Jump to navigation
Jump to search
Line 31:
Line 31: − + − + − + − + + Line 51:
Line 52: +
→Installation
**bridgeInterface is the name of the bridge device (usually br0)
**'''bridgeInterface''': (br0) is the name of the bridge device (usually br0)
**ethernetInterface is the real interface you want to bridge. It should allready be set to your actual InternalInterface
**'''ethernetInterface''': (eth0|eth1) is the real interface you want to bridge. It should allready be set to your actual InternalInterface
**tapInterface is a list of tap interfaces to create and add to the bridge. Usually, you'll only need one tap interfcae (tap0)
{{Note box|The bridge contrib is not compatible with the NIC bonding option. If you're running in serveronly mode and use NIC bonding, you should disable it before starting the bridge}}
**status is the status of the service (should it be started automatically on boot)
**'''tapInterface''': (tap0,tap1) is a comma separated list of tap interfaces to create and add to the bridge. Usually, you'll only need one tap interfcae (tap0)
**'''status''': (enabled|disabled) is the status of the service (should it be started automatically on boot)
Once you're sure everything is ok, just start the service:
Once you're sure everything is ok, just start the service:
br0 8000.00e04c101418 no eth0
br0 8000.00e04c101418 no eth0
tap0
tap0
=== Uninstall ===
=== Uninstall ===
yum remove smeserver-bridge-interface
yum remove smeserver-bridge-interface