OpenVPN Routed

Languages:

English

Maintainer

Daniel B. from Firewall Services

Description

OpenVPN is a full-featured open source SSL VPN solution that accommodates a wide range of configurations, including remote access, site-to-site VPNs, Wi-Fi security, and enterprise-scale remote access solutions with load balancing, fail-over, and fine-grained access-controls. Starting with the fundamental premise that complexity is the enemy of security, OpenVPN offers a cost-effective, lightweight alternative to other VPN technologies that is well-targeted for the SME and enterprise markets.

This contrib will help you configuring OpenVPN in routed mode. With this mode, clients connecting to the VPN from the outside will get an IP in a virtual private network. (this network will use a separated IP range from your standard local network, unlike the OpenVPN_Bridge contrib

Requirements

• SME Server 8.0 (serveronly or server&gateway works)
• You may want to install PHPki to manage easily your certificates.

	Warning:
	The current version has mainly be written to allow smartphone device to be able to connect as bridge interface are not supported.

Installation

install the rpms (7.x) and (8.x)

install fws repo, see : Fws

then :

yum  install smeserver-openvpn-routed --enablerepo=fws,smecontribs

Configure

refer to OpenVPN_Bridge

Configure as running in parallel of bridge contrib

1. install
2. change port

config setprop openvpn-routed UDPPort 1195

1. copy bridge certificates

cp -a /etc/openvpn/bridge/{priv,pub} /etc/openvpn/routed/

1. if you want to change the default network range assigned (192.169.29.0)

db configuration setprop openvpn-routed Network 192.168.79.0/255.255.255.0

1. signale event to regenerate all you need

signal-event openvpn-routed-update