Raidstatus
Raidstatus for SME Server
Maintainer
Stephane de Labrusse aka stephdl
Description
This contribution for SME Server adds the abilities to check the status of your software Raid in server-manager
Installation
This contrib is currently held in an external non default repository. You must first configure the stephdl repository on your SME server by following the steps here stephdl (if not already configured).
You can check the repo status as follows
db yum_repositories show stephdl
If you receive no output then the repo is not configured on your SME server.
Then run the following commands to install the Raidstatus contrib on your SME Server.
yum --enablerepo=stephdl install smeserver-raidstatus
Then activate the database changes as follows:
signal-event post-upgrade; signal-event reboot
or if you do not want to restart the server, simply do
signal-event console-save
Go to the Server Manager and check the status of raid
In case the raid is unsynchronized, please check the documentation at http://wiki.contribs.org/Raid:Manual_Rebuild.
Usage
RED : You have a desynchronized raid, please check which drive is failed and if possible try to add it again
ORANGE : A Raid array is synchronizing or you have installed SME Server on a single drive
GREEN : All is Ok, you can return to work
mailto
This contribs send a mail every sunday with the status of each array of your software raid. The recipient is admin but you change this by a db command
config setprop raidstatus mailto "foo@foo.com"
or if you need several recipients
config setprop raidstatus mailto "foo@foo.com foo@foo.be foo@foo.fr"
Uninstall
yum remove smeserver-raidstatus signal-event post-upgrade; signal-event reboot
Bugs
Not yet a component in bugzilla, please raise a bug in the unknown section.
