Freeswitch

	Work in Progress:
	This page is a Work in Progress. The contents off this page may be in flux, please have a look at this page history the to see list of changes.

About

"Freeswitch is a scalable open source cross-platform telephony platform designed to route and interconnect popular communication protocols using audio, video, text or any other form of media. It was created in 2006 to fill the void left by proprietary commercial solutions. FreeSWITCH also provides a stable telephony platform on which many applications can be developed using a wide range of free tools".

Please visit the http://freeswitch.org website for more detailed information.

Installation

Both the Freeswitch and Epel repositories have to be enabled. Please enable these repositories first. After enabling the above repositories, one can install Freeswitch and it's dependencies with yum:

yum install --nogpgcheck freeswitch-config-vanilla --enablerepo=freeswitch --enablerepo=epel

This will install about 60 RPM's with an installed size of 35M.

	Note:
	If you have installed the SOGo contrib, you will encounter a dependency issue with libmemcached. There is no resolution yet and your input is welcomed.

Configuration

Adding Freeswitch as a service and open ports

To automatically start Freeswitch at boot and configure the ports:

ln -s /etc/rc.d/init.d/e-smith-service /etc/rc7.d/S99freeswitch
config set freeswitch service 
config setprop freeswitch status enabled
config setprop freeswitch access private
config setprop freeswitch UDPPorts "5060,5070,5080,3478,3479,16384:32768"
config setprop freeswitch TCPPorts "5066,7443"

You can toggle the access property to enable public/private access. Then to apply the new service:

signal-event remoteaccess-update

Freeswitch can now be started and stopped with

service freeswitch start
service freeswitch stop

FusionPBX freeswitch GUI

Like other PBX systems, freswitch has many options and can me managed from the command line interface (CLI) which for Freeswitch is 'fs_cli'. However a stable GUI for Freeswitch is freely available from FusionPBX. FusionPBX is only the Graphical interface and relies on a correctly installed Freeswitch engine.

Installation

First we need to create a mysql database for FusionPBX where it keeps its configurations.

mysqladmin create fusionpbx

then we enter the mysql cli:

mysql
grant all privileges on fusionpbx.* to 'admin'@'localhost' identified by 'very_strong_password';
flush privileges;
exit

• svn checkout of FusionPBX
• setting permissions
• change install.php and replace 127.0.0.1 with localhost
• set openbasedir of the Primary to /