Tftp server

Languages:

English

smeserver-tftp-server

Maintainer: Trevor Batley
Current vesrion: 1.0-2

Description

This contribution adds a tftp server (tftp-server) to your smeserver (primarily used by workstations that are using the pxeboot protocol to retrieve boot images and parameters from the server).

It was produced to support my smeserver-thinclient contrib, but can be used independently.

I also have a sister contrib that uses atftp-server, if you prefer that server. It works the same as this one and is interchangeable.

Requires

• smeserver >= 7.0
• tftp-server >= 0.39

Installation

This contrib is currently held in the smedev repository (I will try to move it into smeextras or smeaddons), so the following commands will install on your smeserver.

yum --enablerepo=smedev install smeserver-tftp-server

or if you don't have the Centos base repository enabled

yum --enablerepo=smedev --enablerepo=base install smeserver-tftp-server

Officially you should then need to activate the database changes etc., but this is not required for this package.

signal-event post-upgrade
signal-event reboot

The tftpd status is controlled via the Thin Clients server-manager panel if you have installed my smeserver-thinclient contrib.

If you haven't, you'll need to enable the tftp server and expand all the templates etc.

config setprop tftpd status enabled
signal-event tftpd-conf

If for any reason the tftp server isn't running, try:

/etc/init.d/supervise/tftpd restart

Defaults

You shouldn't need to play with any parameters (except status). The defaults and allowed values are listed below.

<prop>	default <value>	allowed Values	description
status	disabled	enabled/disabled
access	private	private/public/localhost	private = internal interface ONLY public = all interfaces localhost = localhost ONLY
log	normal	normal/verbose/disabled	normal = -v verbose = -vv disabled = none
user	root	root/nobody	should default to nobody, but this doesn't work
privelege	ro	ro/rw
timeout	default	default/300	default = 900 seconds (15 minutes)
UDPPort	69	any port
directory	/tftpboot	any directory

These settings can be set/changed via

config setprop tftpd <prop> <value>
signal-event tftpd-conf

Uninstall

yum remove smeserver-tftp-server tftp-server

Everything should be turned off, but if not, or you just want to make sure

/etc/init.d/supervise/tftpd stop

An error saying that /etc/init.d/supervise/tftpd does not exist should be returned

Source

The source for this contrib can be found in the smeserver CVS on sourceforge.

A copy is held in my contribs directory.

Bugs

Please raise bugs under the SME-Contribs section in bugzilla and select the smeserver-tftp-server component or use this link .

---