Difference between revisions of "UpgradeDisk"

From SME Server

Revision as of 13:44, 11 April 2007

Hard drive restore requires a complete system. It is meant to take a hard drive from a system, mount it, and do a restore from it.

On the old SME server prior to shutting down do signal-event pre-backup then shutdown & remove the drive
On the new machine do a fresh install of sme7
Shut down & install old drive and start machine.
mkdir /mnt/tmp
mount /dev/hdb2 /mnt/tmp (adjust "hdb2" according to where the old drive is installed).
db configuration setprop backup Program CopyFromDisk status enabled
signal-event pre-restore
signal-event restore-tape /mnt/tmp (note: this step may take a long time depending on how much data is being restored
cd /etc/e-smith
mv templates-custom templates-custom.old
mkdir templates-custom
mv templates-user-custom templates-user-custom.old
mkdir templates-user-custom
signal-event post-upgrade
signal-event reboot
Shutdown and remove old drive

@@ Line 1: / Line 1: @@
 ==Upgrade Disk==
+Hard drive restore requires a complete system.  It is meant to take a hard
+drive from a system, mount it, and do a restore from it.
 Summarised from http://forums.contribs.org/index.php?topic=30745.0
@@ Line 6: / Line 9: @@
 # On the new machine do a fresh install of sme7
 # Shut down & install old drive and start machine.
-# cd /
 # mkdir /mnt/tmp
-# mount /dev/hdb2 /mnt/tmp (adjust "hdb2" according to where the 6.0 drive is installed).
+# mount /dev/hdb2 /mnt/tmp (adjust "hdb2" according to where the old drive is installed).
 # db configuration setprop backup Program CopyFromDisk status enabled
 # signal-event pre-restore